hi
we dont have problem running 2.4.3-20 kernel on
mandrake 8. i have also just installed 2.4.7 and it
went fine.
could you give a snap shot of the 'few lines' you are
referring to? maybe that will give us a clue.
dm
--- Pete Jordan <[EMAIL PROTECTED]> wrote:
> Bill Beauchemin <[EMAIL PROTECTED]> wrote:
>
> > This is nice but i am still unable to get smp to
> work on my box. Im
> > almost ready to go back to slackware kernel 2.4.16
> which ran smp just
> > fine.
> >
> > When I try to run the smp kernel that mandrake had
> setup on install it
> > goes through a few lines and then reboots the
> machine.
>
> Is it an ASUS board? You may have the same problems
> I had with the VIA
> 686a controller. I can't find the link now
> (naturally ;) and don't want to
> reboot just to peer at BIOS settings, but if this
> matches your setup
> there's an option you need to disable in the "Boot"
> section of the BIOS
> screens. It's *something* 14 about half way down,
> and I don't think
> there's anything else similar in there.
>
> Sorry I can't be more specific...
>
> Pete
>
>
>
=====
This email is for the above named person/s only. Usual legal
bullshit covering my own ass applies. Be prepared to get
fucked if you dare misuse the above information. If you
receive this message in error, your existence in this world
must also be an error. Please go and die! You must not
communicate this message to anybody else or I'll send
my friends to look for you. Death to all stupid signatures!
__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/
