Hi,
My old motherboard's IDE died, so I replaced it with a new AOPEN AK73
PRO(A). On the old motherboard, I used a ZoomCam USB cam with no problems.
I just loaded the modules and everything worked. The uhci always used IRQ
3 on my old system. Now, basically everything but the motherboard is the
same and when I load usb-uhci (modprobe usb-uhci), I get
PCI: Found IRQ 3 for device 00:07.2
IRQ routing conflict in pirq table for device 00:07.2
IRQ routing conflict in pirq table for device 00:07.3
usb-uhci.c: Detected 2 ports
PCI: Found IRQ 3 for device 00:07.3
IRQ routing conflict in pirq table for device 00:07.2
IRQ routing conflict in pirq table for device 00:07.3
usb-uhci.c: Detected 2 ports
the devices 00:07.2 and .3 are the following (cat /proc/pci
Bus 0, device 7, function 2:
USB Controller: VIA Technologies, Inc. UHCI USB (rev 22).
IRQ 11.
Master Capable. Latency=32.
I/O at 0xd400 [0xd41f].
Bus 0, device 7, function 3:
USB Controller: VIA Technologies, Inc. UHCI USB (#2) (rev 22).
IRQ 11.
Master Capable. Latency=32.
I/O at 0xd800 [0xd81f].
and usb-uhci adds itself for IRQ 11 (cat /proc/interrupts)
0: 6062202 XT-PIC timer
1: 23933 XT-PIC keyboard
2: 0 XT-PIC cascade
7: 160 XT-PIC via82cxxx
10: 1050611 XT-PIC eth0
11: 2 XT-PIC usb-uhci, usb-uhci
12: 34724 XT-PIC PS/2 Mouse
14: 179587 XT-PIC ide0
15: 4 XT-PIC ide1
NMI: 0
ERR: 0
Well, when I modprobe cpia, my webcam modules, I get this :
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=2 (error=-110)
usb_control/bulk_msg: timeout
usb.c: USB device not accepting new address=3 (error=-110)
I would really appreciate ANY help on this, as I am completely lost. I
have tried many things, especially changing a lot of BOIS settings .TIA
