can anyone suggest what is wrong with my scanner. here is what happens ( --> is my root prompt ). scanner works well with doze. -->modprobe scsi_hostadapter aha152x: BIOS test: passed, detected 1 controller(s) aha152x0: vital data: PORTBASE=0x140, IRQ=9, SCSI ID=7, reconnect=enabled, parity=enabled, synchronous=disabled, delay=100, extended translation=enabled aha152x: trying software interrupt, ok. scsi0 : Adaptec 152x SCSI driver; $Revision: 1.7 $ scsi : 1 host. Vendor: AGFA Model: SNAPSCAN 310 Rev: 1.10 Type: Scanner ANSI SCSI revision: 02 Detected scsi generic sga at scsi0, channel 0, id 2, lun 0 -->find-scanner find-scanner: found scanner "AGFA SNAPSCAN 310 1.10" at device /dev/scanner find-scanner: found scanner "AGFA SNAPSCAN 310 1.10" at device /dev/sg0 find-scanner: found scanner "AGFA SNAPSCAN 310 1.10" at device /dev/sga -->scanimage P6 # SANE data follows 2539 3416 255 [hangs until ^C] scanimage: stopping scanner... scanimage: sane_read: Operation was cancelled -->scanimage -T scanimage: scanning image of size 2539x3416 pixels at 24 bits/pixel scanimage: acquiring RGB frame, 8 bits/sample scanimage: reading one scanline, 7617 bytes... FAIL No data scanimage: reading one byte... FAIL No data scanimage: stepped read, 2 bytes... FAIL No data scanimage: stepped read, 4 bytes... FAIL No data scanimage: stepped read, 8 bytes... FAIL No data scanimage: stepped read, 16 bytes... FAIL No data scanimage: stepped read, 32 bytes... FAIL No data scanimage: stepped read, 64 bytes... FAIL No data scanimage: stepped read, 128 bytes... FAIL No data scanimage: stepped read, 256 bytes... FAIL No data scanimage: stepped read, 512 bytes... FAIL No data scanimage: stepped read, 1024 bytes... FAIL No data scanimage: stepped read, 2048 bytes... FAIL No data scanimage: stepped read, 4096 bytes... FAIL No data ....etc Robert
Want to buy your Pack or Services from MandrakeSoft? Go to http://wwww.mandrakestore.com
