The connection are ok , is the autodetection not working properly forcing 10base2 with diagnostic under dos
it works properly Pierfrancesco kons Richard Bown wrote: > On many dual port ethernet cards, the rj45 is enabled automatically if > the BNC port is not terminated with 50 ohm terminations at each end of > the cable, > Have you made sure the network is connected to the card and is correctly > terminated on boot up ? > > HTH > > Pierfrancesco Tateo wrote: > > > > No jumper , I discover to setup using dos disk saled with the cards. > > > > But how to do with my old pcmcia ethernet card that have BNC and RJ connector > > ? > > > > Pierfrancesco > > > > Will wrote: > > > > > I don't know about the Realtek specifically, but most of those BNC/RJ45 combo > > > cards I've seen have a jumper to set which port they use. > > > > > > On Tuesday 20 November 2001 09:46 am, Pierfrancesco Tateo wrote: > > > > Using MDK80 Realtek 8029 > > > > > > > > How to activate the BNC connection instead of RJ ? > > > > > > > > Best Regards > > > > > > > > Pierfrancesco Tateo > > > > > > > > > > > > > > > > > -- > Richard Bown > Ericsson Microwave Systems AB > SE-431 84 M�lndal > e-mail [EMAIL PROTECTED] > tel +46 31 74 72422 > mobile +46 7098 72422 > > ------------------------------------------------------------------------ > Want to buy your Pack or Services from MandrakeSoft? > Go to http://www.mandrakestore.com
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
