What is in your /etc/modules.conf file? Do you have your BIOS set to something like PNP OS + no? Is this a PCI or ISA card?
Norman wrote: > > Well I hoped that editing rc.local and including the line > > ifup eth0 > > would work but it didn't. All I got was : > > Delaying eth0 initialization which is the same message I > > get at boot time. > > If I try to run Harddrake and select network device cards > > then my card is seen. If I elect to configure it I get the message : > > Modprobe : Can't locate module eth0 > > If I run Mandrake control center and select Network & internet > > and then connection then in the right hand pane > > on the line which says status disconnected and has a button labeled > > connect clicking on that button does connect me and I can surf and > ping > > to my hearts delight :-) until I re-boot and I am back to square one. > > It does not seem to matter if I apply the settings or not. > > Once it is running cat/proc/interrupts shows the card assigned irq10 > > cat /proc/ioports shows various outputs > > Help!!! please before I go mad > norm -- Sword'sEdge VoiceMail/Fax: (858) 860-6406 x1587
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
