Hi Buchan and All, : Did you join the domain? I assume it's a windows (NT or 2k?) : domain?
Yes it is joined to the NT PDC. wbinfo -t says secret is good. : The default is "\", comment it out rather, as it's quite : difficult to get it right (you must have the quotes). Also, : for ACLs etc, it might be worthwhile disabling 'winbind use : default domain', at least to test ... I think the mismatched winbind separator is the cause. I made write_list and print_admin @"MyDomain\Print Admins" and the winbdin separator to "\". : This looks a bit suspect ... the one below for your hp5p loks : right : > print command = lp -d %p -o raw %s; rm -f %s Thanks I copied that from Samba Essentials for Windows Administrator 8( But I'm able to print on the LM9.0 box. : > [hp5p] : > comment = HP LaserJet 5P--Show Room : : You should use /var/spool/samba here unless you reall know what : you are doing. Anyway, in most cases you don't need per-printer : config, unless your printing defaults (in [printers]) are wrong. Thanks I changed that as well. I now successfully uploaded the W2K drivers from a W2K workstation. But can't upload NT4.0 drivers. I tried on a NT4.0 workstation it says they are uploaded, but I checked the directory. It's empty. Do you know why? Also I can't upload drivers by browsing server properties in printers. I can only do it by selecting the printer then add new driver. The books tells me otherwise. Also the print job from a windows machine prints out a page with some PJL commands, then a page of the print out and then some garbage. I assume this is driver's fault. Can it be because I have a Raw device setup in CUPS? They don't offer the printer driver (HP5P) when I choose add printer. I needed to select RAW device initially? I hope I'm not getting too annoying. And thank you in advance for your patience and expert advice. Regards, Norman
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
