Hi Everyone, I am having problems with what looks like scsi emu probs, I am using mandrake 9 and a Duron 1.3g .. the problem is I have a LG 48x16x48 cdr drive no matter what i try I can not burn quicker than 8x with out having problem like
./cdrecord: Input/output error. send opc: scsi sendcmd: no error CDB: 54 01 00 00 00 00 00 00 00 00 status: 0x2 (CHECK CONDITION) Sense Bytes: 70 00 06 00 00 00 00 0A 00 00 00 00 29 00 00 00 Sense Key: 0x6 Unit Attention, Segment 0 Sense Code: 0x29 Qual 0x00 (power on, reset, or bus device reset occurred) Fru 0x0 Sense flags: Blk 0 (not valid) cmd finished after 60.041s timeout 60s ./cdrecord: OPC failed. Writing time: 65.709s BURN-Free was never needed. ./cdrecord: fifo had 64 puts and 0 gets. ./cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%. O.k. I have pulled down the latest cdrecord,compiled it, but does not look like the problem.. since it does work at 8x.. had a play with hdparm, switching off and on DMA, but it does not seem to make much difference... any ideas? Cheers Mark
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
