On Mandrake 9.1, with lm_sensors-2.7.0-2mdk, I have run sensors-detect
and accepted the default settings. The oddity is that the sensors
command, or gkrellm, or ksensors only show the value (at least for
temps, which is obvious) that exists at boot time. In other words,
first boot on a cool morning will show a relatively low temp that does
not change throughout the session. Subsequent boots will show a,
logically, warmer temp that, also, does not vary. This has been the
case from the stock kernel through the current 2.4.21-0.18mm-mdk. I've
just noticed the following message in syslog and wonder if it suggests
some clue to anyone?
Jul 20 08:30:53 localhost kernel: i2c-ali1535.o: Resetting entire SMB
Bus to clear busy co
ndition (08)
Jul 20 08:30:53 localhost kernel: i2c-ali1535.o: SMBus reset failed!
(0x08) - controller o
r device on bus is probably hung
Rolf
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
