Ok, so I installed the rpm, and lo and behold, my mobo is finally supported.
Running sensors-detect, I was able to find several items of use, and I added
them to modules.conf, as I was told by the script.
I have loaded:
w83781d
eeprom
i2c-proc
i2c-dev
i2c-philips-par
parport
i2c-elv
i2c-algo-bit
i2c-nforce2
i2c-core
And now I am running sensors at the command prompt:
# sensors
eeprom-i2c-0-50
Adapter: SMBus nForce2 adapter at 5000
Algorithm: Non-I2C SMBus adapter
eeprom-i2c-0-51
Adapter: SMBus nForce2 adapter at 5000
Algorithm: Non-I2C SMBus adapter
as99127f-i2c-1-2d
Adapter: SMBus nForce2 adapter at 5500
Algorithm: Non-I2C SMBus adapter
VCore 1: +1.64 V (min = +1.47 V, max = +1.61 V) ALARM
VCore 2: +1.66 V (min = +1.47 V, max = +1.61 V)
+3.3V: +3.32 V (min = +3.13 V, max = +3.45 V)
+5V: +4.99 V (min = +4.72 V, max = +5.24 V)
+12V: +11.86 V (min = +10.79 V, max = +13.19 V)
-12V: -12.40 V (min = -0.00 V, max = -0.00 V)
-5V: -4.70 V (min = -0.00 V, max = -0.00 V)
fan1: 14361 RPM (min = 3000 RPM, div = 2)
fan2: 3139 RPM (min = 3000 RPM, div = 2) ALARM
fan3: 5192 RPM (min = 3000 RPM, div = 2)
temp1: +33�C (limit = +60�C)
temp2: +35.4�C (limit = +120�C, hysteresis = +100�C)
temp3: +255.4�C (limit = +120�C, hysteresis = +100�C)
vid: +1.550 V
alarms:
beep_enable:
Sound alarm enabled
Now, what do I know about this system? Where do I go from here? And what about
the bogus reading on fan1? And how about the boundaries, can I be certain
that they are correct for my system? How do I get ksim, or any other hardware
monitoring client working?
Basically I am an estatic hardware monitoring clueless dude, and need a little
help.
Rob
--
Linux: For the people, by the people.
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
