Thanks for the reply. Any ideas how to kill with an open circuit. Is there
a ground for something I could use ?
I'm putting an electric start on a 494 w/ total loss ignition. I was
planning on running the ground cable for battery through the master switch,
somehow have to figure out how to kill the engine as well.
If anybody has any ideas, I sure would appreciate it. I'm stumped.
Thanks, Joe
----- Original Message -----
From: "JBlumenthal" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Monday, January 15, 2007 6:53 PM
Subject: Re: [F500] CDI 494 Rotax Wiring question
Ground to kill. For some instruments, this wire also supplies the tach
signal.
-Jeff B.
Joe wrote:
I believe the black with yellow is the ignition key wire on a 494. Does
this
ground to kill ignition or go open to kill ignition ?
Thanks, Joe
________________________________
FormulaCar Magazine - A Proud Supporter of Formula 500
The Official Publication of Junior Formula Car Racing
Subscribe Today! www.formulacarmag.com or 519-624-2003
_________________________________
_______________________________________________
F500 mailing list - [email protected]
To unsubscribe or change options please visit:
http://f500.org/mailman/listinfo/f500
*** Please, DO NOT send unsubscribe requests to the mailing list! ***
