Subject: Advice on tuning a cubicnl-based guitar distortion

Hello FAUST users,

I am a high school student and a guitarist in Singapore, and I have been
working on a project that uses FAUST-based guitar effects with ML models
for effects settings estimation. Listening tests with external guitar tones
have made me question whether the current distortion block I use is too
simple perceptually. This is what I have, based on ef.cubicnl:

pre_hp_hz     = 130;   // high-pass before the cubicnl
tone_min_hz   = 1000;  // tone filter cutoff
tone_range_hz = 6000;  // tone = 1 -> 7000 Hz
cubic_dist(drive, tone) =
    fi.highpass(1, pre_hp_hz)
    : ef.cubicnl(drive, 0.1) : fi.dcblockerat(35)
    : fi.lowpass(1, tone_min_hz + tone * tone_range_hz);
process = cubic_dist(hslider("drive", 0.5, 0, 1, 0.01), hslider("tone",
0.5, 0, 1, 0.01));

My questions:

1. What is the best way to tune the offset in ef.cubicnl to increase even
harmonics for a more amp-like sound? Does the best offset depend on the
drive setting? Any other alternatives?
2. Should I reduce the pregain, something like ef.cubicnl(*drive * 0.75*,
0.1), to limit hard clipping at high drive input?
3. Tone knob: would an even (logarithmic) taper, for example a cutoff of
1000 * 7^tone, be better than the current linear mapping from 1 kHz to 7
kHz?
4. Is it true that this block does not fully turn off at drive 0, because
the filters and the offset stay active? If so, what is the recommended
workaround?

I know I am asking for a lot here, but feedback on any of the above will
really help. I really want to improve my model and estimation. If you have
any questions, I am happy to answer.

Thank you very much.

Best regards,
Aarush
_______________________________________________
Faudiostream-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/faudiostream-users

Reply via email to