Am 04.12.2020 um 18:14 schrieb Paul B Mahol:
On Wed, Dec 2, 2020 at 11:11 PM Michael Koch <[email protected]>
wrote:
Am 01.12.2020 um 19:56 schrieb Michael Koch:
Hello,
there seem to be some problems in the v360 filter with "perspective"
output.
Tested with the latest Windows built, 2 days old. You can reproduce
this with any equirectangular input image.
ffmpeg -i equirectangular_test.png -lavfi v360=e:perspective -y out1.png
The output of the above command has two problems:
-- The center of the input image is not mapped to the center of the
output image. For most other projections the image center is preserved.
-- The output is mirror reversed (which means you cannot read text).
Both problems can be corrected with this workaround:
ffmpeg -i equirectangular_test.png -lavfi
v360=e:perspective:pitch=90:v_flip=1 -y out2.png
Now I want to add a yaw rotation after the pitch rotation:
ffmpeg -i equirectangular_test.png -lavfi
v360=e:perspective:rorder=pyr:pitch=90:yaw=20:v_flip=1 -y out3.png
But in the output you can see that a roll rotation was done.
Today I did for the very first time figure out how to compile ffmpeg.
The above problem can be solved by changing two lines in vf_v360.c
Sorry, I haven't yet figured out how to use git.One thing after the
other...
Old version:
line 3136: vec[1] = sin_theta;
line 3137: vec[2] = cos_theta * cos_phi;
New version:
line 3136: vec[1] = cos_theta * cos_phi;
line 3137: vec[2] = sin_theta;
I'm not sure if lines 3139 to 3141 must also be changed.
Good job!
Please write a patch with correct authorship and send it to the devel list.
Fixing this for you was much more work than writing & sending patch will be.
Can you please explain what's the exact meaning of "v_fov" with
perspective output?
I think it might be the distance from the camera to the surface of the
sphere, normalized to the sphere's radius. But only approximately.
What's the default value and where in the source code is it set?
Michael
_______________________________________________
ffmpeg-user mailing list
[email protected]
https://ffmpeg.org/mailman/listinfo/ffmpeg-user
To unsubscribe, visit link above, or email
[email protected] with subject "unsubscribe".
