Hi folks - The only place around here where I can see an Epson 2450 is CompUSA and those clerks know jack. I asked to see a manual and no go either. Criminy. Anyway, I was looking at the transparancy/negative carrier and trying to figure out how it worked. There may have been a piece that wasn't on display. What I saw saw was a bracket with a wavy-edged slot for sliding a negaitive strip into, and then 4 or 5 6x6cm or 2x2" cutouts in the same piece, I assume for slides and MF negatives. But how would you feed a strip of 6x6 negs? Do they have to be cut into individual frames? Or hold a slide in for that matter? I'm not exactly sure of the size of the cutouts, whether it was 2x2 for slides or 2 1/4 x 2 1/4 for MF. The cutouts didn't have a lip to hold a the mounted slide in postion, nor did they look they were set up for a snap fit.
Any illucidation welcome, thanks. Ken Durling Visit my new easier-to-browse PhotoSIG portfolio: http://www.photosig.com/browse.php?id=photographer:203 ---------------------------------------------------------------------------------------- Unsubscribe by mail to [EMAIL PROTECTED], with 'unsubscribe filmscanners' or 'unsubscribe filmscanners_digest' (as appropriate) in the message title or body