Again, maybe this has been covered, but if so, I didn't see it. FinMac2007c.
Example: I have two parts I enter on the flute line. They are
in 4ths. I explode them so that the top note will be on the flute
staff, and the bottom note will be on the oboe (2nd) staff. The
HIGHER notes of the figure, appear, on the top staff as the LOWER
notes in unison with the oboe.
More detail, same example. It is a three-note figure, 2 8ths
and a half note. The top voice is D (middle of treble staff) up to
high C, down to Bb. The low voice is A (under the D), up to G, down
to F. When I explode, the low voice is right, but the top voice is
D, G, F (the last 2 note unison with the low part).
Any solutions? Using the Note Mover tool is one solution, but
a lot more steps.
All the best,
KIM R
I have reported this bug to this list and to tech support at MM. So
far their response has been infuriatingly dumb. (2 months of stupid
delays and seeming inability to read what I have written to them.)
Please send your file and complaint to MM so that they might start to
take this seriously.
Just out of curiosity, did this file start with an older template or
have material pasted into it from another file? I think that might
have something to do with it.
-Randolph Peters
_______________________________________________
Finale mailing list
[email protected]
http://lists.shsu.edu/mailman/listinfo/finale
