If it is system margins, make sure "Avoid Margin Collisions" is unchecked in the Page Layout menu. JR
On 2/28/16 1:50 PM, Christopher Smith wrote: > Probably the system margins are very large, either the top margin on the last > system, or the bottom margin on the second-last system. In the Page Layout > tool, can you see the margin handles? > > Christopher > > >> On Feb 28, 2016, at 1:36 PM, Sears, Joel <[email protected]> wrote: >> >> Dear Listers, >> >> A friend sent me an extracted part, with the last staff spaced about four >> spaces too low. He asked if I could fix it. In Staff Tool>Respace Staves, I >> can click the handle and move any staves, and the ones below it, up or down. >> I can move the last staff down and even to the next page, but I can't move >> the staff up, beyond where it is now. I can "Fit Measures" on the last two >> staves, but then I get nine measures on one staff, then selecting the last >> five measures>Fit Measures, just puts that staff back in the same position. >> I tried to delete the staff and then add a new staff, but it went back to >> the same position. I told him that it must be corrupted, but he said that >> he's had similar problems since WinFin 2010. He's now on WinFin 2014.5. >> >> Any help would be appreciated. Thanks >> >> Joel Sears >> _______________________________________________ >> Finale mailing list >> [email protected] >> https://lists.shsu.edu/mailman/listinfo/finale >> >> To unsubscribe from finale send a message to: >> [email protected] > > _______________________________________________ > Finale mailing list > [email protected] > https://lists.shsu.edu/mailman/listinfo/finale > > To unsubscribe from finale send a message to: > [email protected] > _______________________________________________ Finale mailing list [email protected] https://lists.shsu.edu/mailman/listinfo/finale To unsubscribe from finale send a message to: [email protected]
