Any suggestions? thanks
On Sat, Aug 24, 2013 at 5:07 PM, John Assael <[email protected]> wrote: > Hi, I have a very small mesh of 2cm x 1cm (2D) and I have a problem > optimising the cell sizes in Gmsh. At this point I do it by hand with trial > and error and also I saw that the triangulation algorithm affects my > results. For example if I select Frontal I get quite different results. > Could you please kindly suggest me any settings that could balance > precision and performance for such a small size? > Moreover, is there any auto optimisation tool that could help selecting > the optimum cell sizes? > Thank you very much! > Kind regards, > J. > > -- > ..:: ic3man.gr ::.. > software | design | development > _/_/_/ email: [email protected] > _/_/_/ www : http://www.ic3man.gr > ------------------------------------------------------------------ > This e-mail and any attachments are confidential. You may not copy > or disseminate any information contained in them to anyone other > than the intended recipient. If you are not the intended recipient > please contact the sender by reply e-mail and destroy all copies > of the original message immediately. > ------------------------------------------------------------------ > -- ..:: ic3man.gr ::.. software | design | development _/_/_/ email: [email protected] _/_/_/ www : http://www.ic3man.gr ------------------------------------------------------------------ This e-mail and any attachments are confidential. You may not copy or disseminate any information contained in them to anyone other than the intended recipient. If you are not the intended recipient please contact the sender by reply e-mail and destroy all copies of the original message immediately. ------------------------------------------------------------------
_______________________________________________ fipy mailing list [email protected] http://www.ctcms.nist.gov/fipy [ NIST internal ONLY: https://email.nist.gov/mailman/listinfo/fipy ]
