I know the documentation states that HPUX 11.0 is supported (along with any HPUX
supported
interfaces). However, I couldn't get it to work (actually the VAR couldn't!).
Checkpoint support wasn't much help with this either.
It appeared that CKPT wasn't recogonizing the token ring LANn drivers.
Anything in the log was coming up with the loopback device of lo0.
I finally had to install on a Sun Ultra 10 (w/token ring) and it works fine.
Tony.
"eric" <[EMAIL PROTECTED]> on 06/14/2000 09:22:00 PM
To: Tony Montesano/BWO/PVHN@PVHN,
[EMAIL PROTECTED]
cc:
Subject RE: Checkpoint on HPUX 11.0 with Token Ring
:
Yes, FW-1 4.1 supports UX 11.0. It supports the Token interfaces too.
eric.
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of
[EMAIL PROTECTED]
Sent: Wednesday, June 07, 2000 1:37 PM
To: [EMAIL PROTECTED]
Subject: Checkpoint on HPUX 11.0 with Token Ring
Does anyone know if Checkpoint FW1 4.1 runs on HPUX 11.0 with both the
internal
and external interfaces using Token Ring ??
Yea Yea TOKEN RING !!
The CKP doc doesn't indicate any restrictions here.
** maybe someday we'll change over to ether..
Thanks,
Tony Montesano
Phillips-Van Heusen
-
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
