Password Recovery Procedure
1. Take a paper clip and straighted it out because
we are getting read to pick a electronic lock.
2.put a console cable in the back of the 2500/2600
3. Put one end of paper clip in the Female connector
Pin 2 (Rx pin).
4. Locate pin Six (Data Set Ready).
5. Power up 2500/2600
6. Using paper clip Short pin 2 to pin 6 serveral times (one half second to one
second intervals)
7. Remove paper clip and Plug Female connector into Lap Top.
If you have a problem repeat using pins 2 & 5.
Hope this helps - This paper clip Password Recovery goes over
real big at a clients work place. "They love it".
You should be in the diag mode with a > prompt.
Follow normal procedure for recovery.
Hostmaster
"Mail @ faithinchaos.com" wrote:
> Hey,
>
> I'm trying to break into a misconfigured Cisco 2500 router. I have console
> access, but the enable password was lost by someone prior to my arrival, so
> breaking in is my only option at this point. Now, I've done this before and
> have instructions for the different requirements for different Cisco product
> break-ins. My question is this:
>
> WTF is the break sequence in HyperTerminal (Windoze terminal program)???
> CTRL-BREAK doesn't seem to work. Or perhaps I am keying the sequence at the
> wrong time during the hard-boot process?
>
> I also have a Cisco datasheet on different break sequences for different
> applications, and none pertaining to Windoze seem to work.
>
> Its been over a year since I have had to perform this type of procedure, so
> I am forgetting something I am sure. Can anyone out there offer some
> insight?
>
> TIA - big time.
>
> -
> [To unsubscribe, send mail to [EMAIL PROTECTED] with
> "unsubscribe firewalls" in the body of the message.]
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
