Simon,
I'm looking at running the FW-1 scenario, and was wondering if the failover
actually takes 30 seconds? Is this a complexity problem, or is 30 seconds
the best case scenario for failover? Is there any problems with maintaining
connections during the failover process? Anyone else that has this setup
care to comment?
- Paul
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Thursday, August 17, 2000 7:10 AM
To: [EMAIL PROTECTED]
Cc: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: Re: Redundant firewall
It depends on the hardware...
Nokia have FW-1 running on their IP330 and IP440 as a High Availability
bundle. This option will let you run both firewalls concurrently for fault
tolerance AND load balancing!
the High availability module that you can get from Checkpoint will only let
you run the 2 firewalls in a Active/Passive setting, where if one dies, the
other will take over after 30 seconds or so.
You can however go with other alternatives such as Stonebeat which will let
you do much the same as Nokia.
We are going with the Nokia IP440HA bundle, as it comes with 2 IP440's
running checkpoint FW-1.
Simon
"Vijay V"
<[EMAIL PROTECTED] To:
<[EMAIL PROTECTED]>
om> cc:
Sent by: Subject: Redundant
firewall
firewalls-owner@List
s.GNAC.NET
17/08/2000 12:02
Hi� All,
Any pointers on how to setup redundant firewall with FW-1 so if one fails
other one should take over.
i am not plannig for a backup kind of firewall, i want both the firewalls
to be live on the network.
Thanks
Vijay
**********************************************************************
If you are not the intended recipient of this e-mail and have received it
in error, you are on notice that the e-mail and any attached files are
confidential. Please notify us immediately by reply e-mail and then delete
this message from your system. Please do not use, distribute, copy or
take any action in reliance on it as to do so could be a breach
of confidence. The sender does not accept any responsibility for any
loss, disruption or damage to your data or computer system which may occur
whilst using data contained in, or transmitted with, this e-mail. Thank
you for your co-operation. If you need assistance, please contact
Maritz Ltd - tel.: +44 (0)1628 486011 or e-mail: [EMAIL PROTECTED]
**********************************************************************
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
