Hello all, 

We implemented this succesfully, on a project in Greece. I'm not anywhere
near Greece at the moment in order to send you the Router's config file. But
as far as I remember I had to manually configure the Multicast address to
the HSRPed Routers, otherwise the Routers would "see" the multicast address.


Works fine

Spiros

> -----Original Message-----
> From: Chris Tobkin [mailto:[EMAIL PROTECTED]]
> Sent: Friday, January 19, 2001 7:50 PM
> To: [EMAIL PROTECTED]
> Cc: 'Stephen Chiu'
> Subject: RE: StoneBeat FW fullcluster with HSRP
> 
> 
> Seeing as that's our site, I'll put the story behind the details..  A
> facility we installed this for had SBFC installed and running then
> implemented HSRP in front of it..  After we tried 
> unsucessfully to implement
> it, StoneBeat sent a representative to get it to work.. After 
> a few days of
> fiddling with it, they gave up and went back home.  We 
> finally got it to
> work with unicast addresses (which in itself opens up new 
> problems) and all
> the failover/load balancing tests run just fine.  So when 
> using HSRP, since
> StoneBeat couldn't get it to work, we just toss the firewalls 
> into unicast
> and work with it that way..
> 
> // Chris
> [EMAIL PROTECTED]
> 
> -----Original Message-----
> From: Stephen Chiu [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, January 18, 2001 10:10 PM
> To: [EMAIL PROTECTED]
> Subject: StoneBeat FW fullcluster with HSRP
> 
> 
> Hi guys,
> 
> We got a problem during Stonebeat fullcluster for solaris Firewall-1
> installation
> with HSRP routers. Our 2 firewalls are connected to 2 
> different Cisco 5500
> switches,
> which have ISL Vlan with 2 x Cisco 7513 and run HSRP. The problem was,
> whatever which firewall was online, fw1, fw2 or both, only 
> one 7513 can
> connect to
> the firewall's outgoing virtual IP (IP C0 on the gif). We had 
> added static
> mapping to
> the multicast MAC address on the 5500 and both router can 
> ping 2 firewall's
> dedicated IP. The impact was that only those ISP connected
> to the OK router could access the firewall protected site.
> 
> Does anyone has experience on SBFC with HSRP and ISL trunk?
> Some website says SBFC multicast doen't work with HSRP, is it true?
> (http://www.intersec.com/support/stonebeat/sb_cluster.htm)
> 
> Please advise.
> 
> Thanks and regards,
> 
> Stephen
> 
> -
> [To unsubscribe, send mail to [EMAIL PROTECTED] with
> "unsubscribe firewalls" in the body of the message.]
> -
> [To unsubscribe, send mail to [EMAIL PROTECTED] with
> "unsubscribe firewalls" in the body of the message.]
> 
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]

Reply via email to