Did you clear xlate tables on the PIX or any of your arp tables on you routers?
Roy
At 01:47 PM 4/5/01 -0700, you wrote:
>hello,
>I think the answer must be simple, but ....
>
>we have a PIX fw with one inside interface and one outside interface.
>Currently a small un-managed hub is serving 3 servers on the inside net.
>we now have a Cisco 2948G switch to replace the hub. After configuring
>the switch with an inside address and
>route to the inside gateway, we switch the cables from the hub to the
>switch.
>
>the inside systems and switches can see each other via ping. the pIX can
>see them, but nothing on the
>outside network can see the inside host that had been visible with the
>hub. Pinging from the switch out does not work, DNS does not resolve.
>
>Dose the fw need a rule to allow the traffic from the switch to pass in
>and out?? Can the
>switch be set to a "dumb" mode....
>
>I dropped the hub back in place and the network is working as it was.
>
>thanks for any help,
>JEff
>--
>-
>[To unsubscribe, send mail to [EMAIL PROTECTED] with
>"unsubscribe firewalls" in the body of the message.]
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
