I am setting up Cisco Works 2000 and inputting the necessary commands on the
routers and switches.
When it comes to inputting the destination where the device is to send
traps, the syntax is as follows:
snmp-server host 172.16.1.1 community-string
When I look up the command from the router's command line it tells me the
last item is a community-string. However, when I look up the command on the
TAC site it refers to the last item as a password.
If the item is a community string should it be the read or read-write
string? And if it is a password, where do I set this password on the Cisco
Works 2000 server?
Here is where I pulled the article from on the TAC site:
http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/as5xipmo/sysmgt.ht
m#xtocid14875
Thanks,
Chad Markley
-
[To unsubscribe, send mail to [EMAIL PROTECTED] with
"unsubscribe firewalls" in the body of the message.]
