[This message was posted by Erik Nyquist of NASDAQ OMX <[email protected]> to the "General Q/A" discussion forum at http://fixprotocol.org/discuss/22. You can reply to it on-line at http://fixprotocol.org/discuss/read/3d3dcf34 - PLEASE DO NOT REPLY BY MAIL.]
Thanks a lot. For FIX 5.0 SP1, the same info can be found in the FIX-5.0_SP1_VOL-4.doc document at page 82. The spec is a bit contradictionary when it describes the purpose of OrdRejReason (103). This is what the spec above says at page 18: 103, OrdRejReason, For optional use with ExecType = 8 (Rejected). Shouldn't this say? For optional use with ExecType = 8 (Rejected) or ExecType = I (Status) /Erik > > Return an Execution Report 35=8 with following tags 150=I(Status) > 39=8(Reject) 103=5(Unknown Order) 17=0 38=0 14=0 151=0 6=0 > > Please refer: fix-43_VOL-4_with_Errata_20020920.doc page no. 69, Order > State Change Matrices, D29 > > Regards Harish > > > > > > > If I send an OrderStatusRequest(H) (FIX 5.0 SP1) containing a ClOrdID > > that does not exist or refers to an order that I have not permission > > to see, what is the expected behavior of the FIX gateway? > > > > Which of these possible strategies should we consider: > > > > 1. Ignore the request > > > > 2. Return an ExecutionReport having ExecType=I (Status Request) > > > > 2. Return an ExecutionReport having ExecType=8 (Rejected) > > > > I have not been able to find any guidelines in the FIX spec. > > > > So what do you think? > > > > /Erik [You can unsubscribe from this discussion group by sending a message to mailto:[email protected]] -- You received this message because you are subscribed to the Google Groups "Financial Information eXchange" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/fix-protocol?hl=en.
