if swf3 loads into level_1
then in your setup the swf3 will overwrite the swf2, eventhough that
swf2 has loaded the swf3
that is because they both load to _level1 and their is only one level1
in your flash projector
so only the content of root and swf3 will remain
hence their can be multiple _root's in your projector.
you can have a private root for every loaded swf, if you add
this._lockroot=true in each of the loaded swf's ;)
I advice you to forget about levels and just use empty movieclips to
load clips in
Regards,
latcho
nik crosina wrote:
If I load a swf into level 1 of my root time line, and then load
something onto level 2 of the swf i just loaded, which level is it on
in relation to the root? do the numbers add up, or do we start
counting from each level again?
so this is the set up again:
root loads
swf 2 into level 1, which then loads
swf 3 onto (it's?) level 1
swf 3 can also be loaded from the root level, in whihc cas ei load
into level 2, and there is also a button to unload it from level 2.
now i want it to unload also when it was loaded from swf 2, which it
currently doesn't do.
any ideas if that hasn't been too confusing ?
thanks a lot!
_______________________________________________
[email protected]
To change your subscription options or search the archive:
http://chattyfig.figleaf.com/mailman/listinfo/flashcoders
Brought to you by Fig Leaf Software
Premier Authorized Adobe Consulting and Training
http://www.figleaf.com
http://training.figleaf.com
