Hi,
According to the Device Operation Instructions in page 8 in
SST25VF016B datasheet (http://www.sst.com/dotAsset/40371.pdf), I
modify OPCODES O_ST_M25P as below. Then flashrom can flash BIOS
successfully.
Can someone check if any problem or side effect to other boards?
Index: flashrom/ichspi.c
===================================================================
--- flashrom/ichspi.c (revision 796)
+++ flashrom/ichspi.c (working copy)
@@ -174,7 +174,7 @@
{
{JEDEC_BYTE_PROGRAM, SPI_OPCODE_TYPE_WRITE_WITH_ADDRESS, 1}, //
Write Byte
{JEDEC_READ, SPI_OPCODE_TYPE_READ_WITH_ADDRESS, 0}, // Read Data
- {JEDEC_BE_D8, SPI_OPCODE_TYPE_WRITE_WITH_ADDRESS, 1}, // Erase Sector
+ {JEDEC_EWSR, SPI_OPCODE_TYPE_WRITE_NO_ADDRESS, 0}, // Enable Write
Status Register
{JEDEC_RDSR, SPI_OPCODE_TYPE_READ_NO_ADDRESS, 0}, // Read Device
Status Reg
{JEDEC_REMS, SPI_OPCODE_TYPE_READ_WITH_ADDRESS, 0}, // Read
Electronic Manufacturer Signature
{JEDEC_WRSR, SPI_OPCODE_TYPE_WRITE_NO_ADDRESS, 1}, // Write Status
Register
# ./flashrom -w 7sll2069.ROM
flashrom v0.9.1-r796
No coreboot table found.
Found chipset "Intel ICH7/ICH7R", enabling flash write... OK.
This chipset supports the following protocols: SPI.
Calibrating delay loop... OK.
Found chip "SST SST25VF016B" (2048 KB, SPI) at physical address 0xffe00000.
Flash image seems to be a legacy BIOS. Disabling checks.
Writing flash chip... Erasing flash before programming... Erasing
flash chip... SUCCESS.
done.
COMPLETE.
Verifying flash... VERIFIED.
Thank you.
Water Chen
2009/12/8 Water Chen <[email protected]>:
> Hi,
>
> flashrom cannot work on Intel ICH7/ICH7R / SST SST25VF016B (2048 KB, SPI).
> MB: Supermicro X7SLM-L /
> http://www.supermicro.com/products/motherboard/Core2Duo/945/X7SLM-L.cfm
>
> The outputs of 'flashrom -V', 'lspci -nnvvvxxx', 'superiotool -deV',
> 'dd if=/dev/mem of=sm_x7slm.system.rom bs=64k count=1 skip=15' are
> attached.
>
> # ./flashrom -w BIOS_X7SLM-L.ROM
> flashrom v0.9.1-r792
> No coreboot table found.
> Found chipset "Intel ICH7/ICH7R", enabling flash write... OK.
> This chipset supports the following protocols: SPI.
> Calibrating delay loop... OK.
> Found chip "SST SST25VF016B" (2048 KB, SPI) at physical address 0xffe00000.
> Flash image seems to be a legacy BIOS. Disabling checks.
> Writing flash chip... spi_write_status_register failed during command
> execution spi_write_status_register failed Erasing flash before
> programming... Erasing flash chip... spi_write_status_register failed
> during command execution spi_write_status_register failed
> spi_disable_blockprotect failed FAILED!
> ERASE FAILED!
> FAILED!
> Your flash chip is in an unknown state.
> Get help on IRC at irc.freenode.net (channel #flashrom) or mail
> [email protected]!
> -------------------------------------------------------------------------------
> DO NOT REBOOT OR POWEROFF!
>
> Thank you.
> Water Chen
>
_______________________________________________
flashrom mailing list
[email protected]
http://www.flashrom.org/mailman/listinfo/flashrom
