On 10.03.2010 01:44, Carl-Daniel Hailfinger wrote:
> I found this in the Bus Pirate forum, apparently written by Patrick Georgi.
>   

There was one bug: Writes are not allowed to cross a page boundary.
Given that we want to finish the generic chunked write sometime soon,
the patch below (which I shamelessly copied from ft2232spi.c) reduces
write size to 8 and should work for all currently supported SPI chips.

Signed-off-by: Carl-Daniel Hailfinger <[email protected]>

Index: flashrom-buspirate_write_256/flash.h
===================================================================
--- flashrom-buspirate_write_256/flash.h        (Revision 929)
+++ flashrom-buspirate_write_256/flash.h        (Arbeitskopie)
@@ -504,6 +504,7 @@
 int buspirate_spi_shutdown(void);
 int buspirate_spi_send_command(unsigned int writecnt, unsigned int readcnt, 
const unsigned char *writearr, unsigned char *readarr);
 int buspirate_spi_read(struct flashchip *flash, uint8_t *buf, int start, int 
len);
+int buspirate_spi_write_256(struct flashchip *flash, uint8_t *buf);
 
 /* dediprog.c */
 int dediprog_init(void);
Index: flashrom-buspirate_write_256/buspirate_spi.c
===================================================================
--- flashrom-buspirate_write_256/buspirate_spi.c        (Revision 929)
+++ flashrom-buspirate_write_256/buspirate_spi.c        (Arbeitskopie)
@@ -316,4 +316,39 @@
        return spi_read_chunked(flash, buf, start, len, 12);
 }
 
-/* We could do 12-byte writes, but for now we use the generic 1-byte code. */
+int buspirate_spi_write_256(struct flashchip *flash, uint8_t *buf)
+{
+       int total_size = 1024 * flash->total_size;
+       int i;
+
+       spi_disable_blockprotect();
+       /* Erase first. */
+       msg_pinfo("Erasing flash before programming... ");
+       if (erase_flash(flash)) {
+               msg_perr("ERASE FAILED!\n");
+               return -1;
+       }
+       msg_pinfo("done.\n");
+
+       /* FIXME: We could do 12 byte writes, but then we'd have to make sure
+        * not to cross a 256 byte page boundary. This problem only applies to
+        * writes, reads can cross page boundaries just fine.
+        */
+       for (i = 0; i < total_size; i += 8) {
+               int l, r;
+               if (i + 8 <= total_size)
+                       l = 8;
+               else
+                       l = total_size - i;
+
+               if ((r = spi_nbyte_program(i, &buf[i], l))) {
+                       msg_perr("%s: write fail %d\n", __func__, r);
+                       return 1;
+               }
+
+               while (spi_read_status_register() & JEDEC_RDSR_BIT_WIP)
+                       /* loop */;
+       }
+
+       return 0;
+}
Index: flashrom-buspirate_write_256/spi.c
===================================================================
--- flashrom-buspirate_write_256/spi.c  (Revision 929)
+++ flashrom-buspirate_write_256/spi.c  (Arbeitskopie)
@@ -108,7 +108,7 @@
                .command = buspirate_spi_send_command,
                .multicommand = default_spi_send_multicommand,
                .read = buspirate_spi_read,
-               .write_256 = spi_chip_write_1,
+               .write_256 = buspirate_spi_write_256,
        },
 #endif
 


-- 
"I do consider assignment statements and pointer variables to be among
computer science's most valuable treasures."
-- Donald E. Knuth


_______________________________________________
flashrom mailing list
[email protected]
http://www.flashrom.org/mailman/listinfo/flashrom

Reply via email to