On 04.07.2010 14:56, Melchior FRANZ wrote: > Here's my report for: > > NVIDIA MCP65 > MSI MS-7369 "K9N Neo V2" v1.0 (2007) > > After the -V run the machine still booted and behaves normally. :-) > Here the relevant lines from the output: > > Found chipset "NVIDIA MCP65", enabling flash write... chipset PCI ID is > 10de:0441 > ISA/LPC bridge reg 0x8a contents: 0x40, bit 6 is 1, bit 5 is 0 > Guessed flash bus type is SPI > Found SMBus device 10de:0446 at 00:01:1 > SPI BAR is at 0xfec80000, after clearing low bits BAR is at 0xfec80000 > SPI control is 0x0002, enable=0, idle=0 > > Probing for Winbond W25x80, 1024 KB: probe_spi_rdid_generic: id1 0xef, id2 > 0x3014 > Chip status register is 00 > Found chip "Winbond W25x80" (1024 KB, SPI) at physical address 0xfff00000. > > m.
Not sure if that's relevant, but I seem have the same board and my results differ: --- Probing for Macronix MX25L8005, 1024 KB: probe_spi_rdid_generic: id1 0xc2, id2 0x2014 Chip status register is 00 Chip status register: Status Register Write Disable (SRWD) is not set Chip status register: Bit 6 is not set Chip status register: Bit 5 / Block Protect 3 (BP3) is not set Chip status register: Bit 4 / Block Protect 2 (BP2) is not set Chip status register: Bit 3 / Block Protect 1 (BP1) is not set Chip status register: Bit 2 / Block Protect 0 (BP0) is not set Chip status register: Write Enable Latch (WEL) is not set Chip status register: Write In Progress (WIP/BUSY) is not set Found chip "Macronix MX25L8005" (1024 KB, SPI) at physical address 0xfff00000. --- See my other reply from July 3 for the full output. HTH -Kjell _______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
