On 14.07.2010 01:39, [email protected] wrote: > Acked-By: Stephen Kou <[email protected]> > > Dump to show (expected) failure: > > flashrom v0.9.2-r1075 > Calibrating delay loop... OS timer resolution is 1 usecs, 1810M loops > per second, 10 myus = 10 us, 100 myus = 100 us, 1000 myus = 992 us, > 10000 myus = 9995 us, 4 myus = 4 us, OK. > Initializing internal programmer > No coreboot table found. > DMI string system-manufacturer: " " > DMI string system-product-name: " " > DMI string system-version: " " > DMI string baseboard-manufacturer: "Intel Corporation" > DMI string baseboard-product-name: "DX58SO" > DMI string baseboard-version: "AAE29331-404" > DMI string chassis-type: "Unknown" > Found chipset "Intel ICH10R", enabling flash write... chipset PCI ID is > 8086:3a16, > BIOS Lock Enable: enabled, BIOS Write Enable: disabled, BIOS_CNTL is > 0xa > tried to set 0xdc to 0xb on ICH10R failed (WARNING ONLY) > GCS = 0x2e0445: BIOS Interface Lock-Down: enabled, BOOT BIOS Straps: > 0x1 (SPI) > WARNING: SPI Configuration Lockdown activated. > Reading OPCODES... done > SPI Read Configuration: prefetching enabled, caching enabled, FAILED! > This chipset supports the following protocols: FWH,SPI. > Found chip "Winbond W25x16" (2048 KB, SPI) at physical address > 0xffe00000. > Reading flash... Invalid OPCODE 0x03 > Read operation failed! > FAILED. >
Thanks, committed in r1079. Regards, Carl-Daniel -- http://www.hailfinger.org/ _______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
