Hi esko, thanks for your report. Please see the comments at the end of this mail.
Am 03.01.2012 22:13 schrieb ekso: > This chipset is not really supported yet... > flashrom v0.9.4-r1394 on Linux 3.1.0-1-686-pae (i686), built with libpci > 3.1.7, GCC 4.6.1, little endian > flashrom is free software, get the source code at http://www.flashrom.org > > Calibrating delay loop... OS timer resolution is 1 usecs, 1304M loops per > second, 10 myus = 11 us, 100 myus = 101 us, 1000 myus = 1000 us, 10000 myus = > 10008 us, 4 myus = 4 us, OK. > Initializing internal programmer > No coreboot table found. > DMI string system-manufacturer: " " > DMI string system-product-name: " " > DMI string system-version: " " > DMI string baseboard-manufacturer: "Gigabyte Technology Co., Ltd." > DMI string baseboard-product-name: "M61P-S3" > DMI string baseboard-version: "x.x" > DMI string chassis-type: "Desktop" > Found ITE Super I/O, ID 0x8716 on port 0x2e > Found chipset "NVIDIA MCP61" with PCI ID 10de:03e0. > This chipset is marked as untested. If you are using an up-to-date version > of flashrom please email a report to [email protected] including a > verbose (-V) log. Thank you! > Enabling flash write... This chipset is not really supported yet. Guesswork... > ISA/LPC bridge reg 0x8a contents: 0x00, bit 6 is 0, bit 5 is 0 > Flash bus type is LPC > Found SMBus device 10de:03eb at 00:01:1 > MCP SPI BAR is at 0xfec80000 > Strange. MCP SPI BAR is valid, but chipset apparently doesn't have SPI > enabled. > Please send the output of "flashrom -V" to [email protected] with > your board name: flashrom -V as the subject to help us finish support for your > chipset. Thanks. > OK. > This chipset supports the following protocols: LPC. > Serial flash segment 0xfffe0000-0xffffffff enabled > Serial flash segment 0x000e0000-0x000fffff enabled > Serial flash segment 0xffee0000-0xffefffff disabled > Serial flash segment 0xfff80000-0xfffeffff enabled > LPC write to serial flash enabled > Serial flash pin 29 > Serial flash port 0x0820 > Probing for AMIC A25L05PT, 64 kB: 4 byte RDID not supported on this SPI > controller > [...] > Probing for AMIC A25L512, 64 kB: probe_spi_rdid_generic: id1 0xc2, id2 0x2013 > [...] We changed the code which accesses the IT87 SPI controller on your board. Could you please try latest flashrom from svn in verbose mode? That would help a lot. Thanks, Carl-Daniel -- http://www.hailfinger.org/ _______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
