On Fri, 14 Nov 2014 19:34:45 -0800
Justin Hibbits <[email protected]> wrote:

> On Sat, 15 Nov 2014 02:41:22 +0100
> Stefan Tauner <[email protected]> wrote:
> 
> > On Fri, 14 Nov 2014 17:30:34 -0800
> > Justin Hibbits <[email protected]> wrote:
> > 
> > > On Sat, 15 Nov 2014 02:06:50 +0100
> > > Stefan Tauner <[email protected]> wrote:
> > > 
> > > > On Fri, 14 Nov 2014 16:45:39 -0800
> > > > Justin Hibbits <[email protected]> wrote:
> > > > 
> > > > > Hi,
> > > > > 
> > > > > I just checked out the trunk from svn, since it supports the
> > > > > Kabini SPI bus, but I'm unable to flash the BIOS.  I see the
> > > > > following message when I run it as:
> > > > > 
> > > > > 'flashrom -p internal:laptop=force_I_want_a_brick -w
> > > > > myimage.bin'
> > > > > 
> > > > > "Warning: Chip content is identical to the requested image."
> > > > 
> > > > Well... above is pretty much everything to say unless you know
> > > > your image differs from the chip contents. Why do you think there
> > > > is anything wrong?
> > > > 
> > > 
> > > Reading the contents back, I get a different binary than what I
> > > flash in, about 192k into the image.
> > 
> > Hm... the code that produces the warning above does almost the same as
> > a manual read and compare... does the read work reliably (e.g. do
> > files read always have the same md5sum)?
> > 
> 
> Yeah, I tried twice, before and after flashing the new image, and both
> reads are identical.  I could chock it up to a potentially bad read if
> the files differed from the flashed rom on a block boundary, but they
> differ at 192k+89 bytes, so I'm pretty sure it's just not writing the
> image.

Yes, it is definitely not even trying to write because it reads the
flash contents, compares it to the file you give it and thinks they are
equal. Can you please create a log with maximum verbosity (-VVV) while
you try to write and send it to the list, thanks.
It might also be interesting to look at the binaries at some point. You
can upload them to http://paste.flashrom.org/ (posting them here wont
work).

-- 
Kind regards/Mit freundlichen Grüßen, Stefan Tauner

_______________________________________________
flashrom mailing list
[email protected]
http://www.flashrom.org/mailman/listinfo/flashrom

Reply via email to