After many hours of successful operation, I have come across is this; I used the XVTRs form, and set up a button for my MM 28-144 Transverter, as I am awaiting my 15db attenuator I set the button at RX Only, to prevent me bricking the transverter. (am I right in thinking the min power out is 1W?) The system works fine, I was using 6m, 20 & 40, and after a brief foray onto 144Mhz, (using coaxial switch to transverter) and back again to HF, I couldn't not tune or transmit... A quick look in setup shows the RX only set, so I can assume the RX only setting in the XVTR form sets the main RX only, but doesn't Reset it when clicking the HF button to revert to normal operation. Now I know it's not a major problem, but maybe unsetting RX only (if only previously set by using clicking a button setup on the form as RX only) should be automatic... or is that too dangerous? Or have a visible indication on the main screen as to the state of the TX ability (even if it is just greying out both TX lamps (below the VFO displays)
PowerSDR v2.00 Beta SVN:3715 Firmware 2.0.1.2 Firewire 3.5.2.8028 Flex 3000 Windows 7 32 bit AMD quad core, 4Gb ram TI chipset Firewire with dedicated interrupt Regards Steve G6HOQ _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using alpha and beta versions of the software.
