While waiting for comments, please put it in the bug tracker anyway so that if it actually is a bug it will get addressed sooner than later. Let the developers sort out the mess :-)
-Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Ken Danser Sent: Friday, November 12, 2010 5:28 PM To: [email protected] Subject: [FlexEdge] Fw: Transmitting on 2 Freqs. This is a second email that I am sending out to anyone who may had or at lease know something about an "AM" Mode issue. Please read below. I am looking for any comments on the matter. I am not sure if this is a bug or something on my end. Any input might be helpful! Thank you, Ken K3YI Hello, I am not totally sure here, but I think the new Beta is causing the "AM" mode to transmit on more then one frequency. I was on 18.86.5 "AM" and another person came on stating I was transmitting also on 1875.5. I was lucky to have the second receiver to verify this. I place the antenna switch to the "Dummy Load" position and tuned the second receiver to 1875.5 and keyed the Flex 5000 and sure enough there was a signal on 1875.5 AM while transmitting on 1886.5. The strange thing is, I had seen my signal up and down the Pan Adapter. I thought for a minute and then switched to LSB and transmitted and the signal had only showed up on the correct freq. (1886.5) So there may be a bug here on "AM" or its on my end only? Can someone else verify this before in-putting this in the "Bug section" ! PC: XP Ver. 2.0.16 Also did the receive calibration on both receivers before using PowerSDR. I had deleted and removed the old SDR and did a new install from the beginning. Please let me know if I had missed something here that may be causing this situation if it is not a "BUG"! Thank you, Ken K3YI _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
