Don't use RX2. Do it with RX1 and turn on split.
-Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dave Beumer WØDHB Sent: Friday, February 18, 2011 4:56 PM To: [email protected] Subject: [FlexEdge] SATPC32 and V/U I have been trying to figure out a way to monitor reception on 70cm when transmitting on 2m when using SATPC32. So far the only solution I have found is to set RX1 to 2m and RX2 to 70cm with VFO B set to transmit and RX2 option "Auto Mute RX2 on TX " uncheck. The problem is that CAT configuration SATPC32 wants to use - VFO A for downlink (70cm) and VFO B for Uplink (2m) and TX. With VFO's configured the way SATPC32 wants them, I tried unchecking the RX2 setup button "Auto Mute RX1 on VFO B TX " but RX1 mutes when transmit is key. Has anyone solved this issue ? I poked around SATPC32 to see if there was a way to reconfigure it's CAT config, but didn't find anything obvious other than some Parameters for ICOM rigs. I'd really like to use SATPC32's Doppler tuning . Thanks Dave W0DHB _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
