SDR1000, WinXP SP3, HP Pentium 4, 3 Gigs of Ram, CPU runs at about 60%
Whenever I exit the SETUP form PowerSDR crashes when I click the APPLY button.
If I just exit the form by clicking on the X (top right) it doesn't crash but
the settings are still saved. What is the purpose of the apply button when
exiting the form accomplishes the same thing except in my case all the apply
button does is crash PowerSDR? This does not occur in versions 1.18.6 and
prior. It occurs in all the 2.0 versions including 2.0.19 RC1.
SWR takes a little longer to calculate (could be my marginal computer).
"High SWR" indicator lit up a few times and then stopped.
BCI Rejection button is missing the last letter. It reads "BCI Rejectio"
Recorder works fine but sometimes the dialog box doesn't display after
recording is stopped. Pressing enter closes the invisible dialog box.
Tooltips do not always show when you hover the mouse over the buttons. Shows an
outline of the tooltip box with no text.
Receive has gone dead a few times after clicking the MOX. Clicking the Start
button on PowerSDR brings it back to life.
Band buttons act a little weird at times. Sometimes more than one button lights
up and stays lit.
Power output seems a bit lower. I used to average 8 to 10 amps on transmit
peaks on my power supply. Now it only averages 5 to 6 amps. Peak readings on my
watt meter seem fine, though.
These issues may be specific to me and my marginal computer but I just thought
I'd mention it.
The software looks beautiful and I think you folks did a great job.
Edwin Marzan AB2VW
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
