Larry
I don't know all the "why's and where for's" but I have been running DM780
with Mini Deluxe for quite a while now.
In your write up I don't see the mention of DDutil software. The way I have
my system setup is that PowerSDR communicates
thru the DDutil software to "everything" else. In this case DDutil is used
to communicate to Mini Deluxe which in turn communicates to
DM780. This virtually takes all the delay out of the system that you may
see when using HRD. In my case if there is any delay, well I don't notice
it.
So in my case I have the following virtual com ports set up:
Com 4,5 Used for PowerSDR
Com 6,7 Used for PowerSDR PTT to DM780
Com 14,15 Mini Deluxe link to DM780
In this way all CAT commands from PowerSDR go thru DDutil and are echoed to
other devices and software.
You may want to look at the Yahoo Groups for HRD and DDutil. A lot of good
information there.
Don
--------------------------------------------------
From: "Larry Otto" <[email protected]>
Sent: Monday, February 21, 2011 8:28 AM
To: <[email protected]>
Subject: [FlexEdge] Digital
First off - Congrats to all @ Flex for all your hard work in getting us
to .19. Thanks a lot.
Next, I have been trying to get DM780 to receive the CAT commands from my
5000a/2.0.19 RC1. To recap,
using HRD, the latency was quite long, and also was having trouble getting
RF out when keyed up.
By downloading .19, everything with HRD seems to have been improved, but
with a small amount of
latency. I can at least get on running HRD/DM780. After a few contacts,
things seem to be close to normal.
It was recommended that I switch to Fldigi to see if all settings are
correct. Fldigi works as advertised,
so I guess this means VAC and other settings are configured correctly.
It was also suggested I run Mini-Deluxe instead of HRD. After opening MD,
it will not accept the comm port 1
that I use for HRD, and my logging program. (I disabled them before
starting Mini-Deluxe)I use comm # 11 (cat) on the Flex side.
When I put in that port, and save, the config screen goes away, but if I
go back to it, no comm port is listed. In the tray, the icon says
mini is running, but there is no connection, and of course, DM780 does not
see the radio. Also, when I start up Mini, I get the warning "The
Publisher could not be verified." etc, etc. Is this normal? Now, to
complicate matters more, if I leave MD running and try to use the comm
port 1
elsewhere,I get a message already in use. So possibly it is running in
the background and not showing up in the config box?
What I am trying to say, I want to run DM780 with Mini-Deluxe. But there
seems to be a problem with MD connecting with the CAT command.
Whew !
73
W8LO
Larry
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is
used for posting topics related to SDR software development and
experimentalist who are using beta versions of the software.
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software development and experimentalist who are
using beta versions of the software.
