Reset the radio back to factory defaults and start over. The option is at the bottom of the Setup form.
Also enter this as a bug in the bug tracker. -Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jerry Coufal Sent: Tuesday, May 17, 2011 11:38 PM To: [email protected] Subject: [FlexEdge] Transmit Profile Setup Error I installed v2.1.0 and the installation process completed without a problem. I was setting up my custom Transmit Profiles and I enter and apostrophe in one of the profile names. This created the error message "Unhandled exception has occurred in your application. If you click Continue, the application will ignore this error and attempt to continue. If you click Quit, the application will close immediately. Syntax error: Missing operand after 's' operator." I can click "Continue" and the application continues but every time I change TX Profiles the error message reoccurs. I have tried to delete the offending Transmit Profile name but it will not delete and the same error message occurs when I try to delete. Is there any way to delete the offending Transmit Profile name to prevent the error message from popping up when I change TX Profiles? Thanks very much Jerry _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using beta versions of the software.
