I followed these steps and did not duplicate the error. Got power out in all steps, did not get the no RF detected message. However, there was no display of signal in panadapter when doing autotune on 10.105 MHz. When I repeated the steps a second time, all aspects were as expected with power out and display of same.
doug -----Original Message----- >From: "Jim Fuller (N7VR)" <[email protected]> >Sent: Dec 19, 2012 4:16 PM >To: [email protected] >Subject: [FlexEdge] Minor Bug In PowerSDR 2.5.3 > >Hi Guys, > > > >I found a repeatable issue in PowerSDR 2.5.3 that is interesting: > >1) Setup on 10.145 Mhz. > >2) Press ATU. > >3) Error "No Carrier Detected". > >4) Set frequency to 10.105 Mhz > >5) Press ATU - ATU Tune Successful. > >6) Go Back to 10.145 Mhz > >7) Start digital process - Signal shows on screen, but no power out. > _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics.
