Andy, Make sure you have SR (Spur Reduction) off. That would make a displacement between the frequencies on PowerSDR and Skimmer. Otherwise I don't know what the problem might be. I don't think it could be a VAC problem.
73, Ed W2RF -----Original Message----- From: Flexedge [mailto:[email protected]] On Behalf Of Andrew O'Brien Sent: Wednesday, April 24, 2013 9:50 PM To: [email protected] Subject: [FlexEdge] PowerSDR and CW Skimmer not aligned I have got PowerSDR and CW Skimmer working together, the frequency displayed in PowerSDR is the same frequency in the main display of CW Skimmer. However a CW signal nicely centered in PowerSDR does not show in the CW Skimmer waterfall at all. CW signal DO show in Skimmer's waterfall, but not ones heard in PowerSDR's audio. When CW Skimmer lists a CQ call in Call List, it is about 20 Khz off from PowerSDR. I Googled this issue and found some folks with similar issues in 2011. VAC settings were suspect at that time but I did not see a solution , some said the issue went away when VAC was updated to a new version. I am using the latest version and have VAC set up identical to the Flex Knowledge Base screenshots on using CW Skimmer. I note with interest the fact that CW Skimmer has a Frequency Calibration option that is grayed out when I use PowerSDR. . Anyone have an idea or two on where to start? Andy K3UK _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software innovation and other technical SDR topics.
