Dear Nige, Bill, and Tim,
Thank you for the suggestions on how to set JT9.
Since I operate JT65-HF, I used the same Com Ports,
CAT Controls, and VAC audio settings to configure JT9.
The only changes that needs to be done are as follows:
1. PDSR-Setup-CAT Control
a. Change ID as: (to)
TS-2000
b. Check
"Allow Kenwood AI Command"
2. JT9 Configuration
a. Setup-Configuration
b. PTT select DTR
c. Rig: 214
Kenwood TS-2000
3. I open HRD 6 for QSL'ing and Antenna Rotor control.
Nothing else needs to be done with HRD.
Everything else that you set up for JT65-HF; transfer to the
configuration page on JT9.
I thank everyone you for the helpful suggestions. And if
anyone needs help, please email direct.
73, Ernest W4EG on JT65-HF and JT9.1 cc(Ulf in case you want to try JT9)
_______________________________________________
Flexedge mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz
This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for
posting topics related to SDR software innovation and other technical SDR
topics.
