I have just experienced an unusual problem.
Whenever I try to transmit, the filter display on the screen jumps to show
approx. 2600hz wide. (it may be a bit wider)
This happens at any setting of filter width, 6khz
down to minimum.
When I stop transmitting it goes back to the
correct initial setting such as set in Var 1.
This hasn't happened before and what would cause
this.
Advice please.
Best wishes
Ross
psI I second the comment about muting. The SDR1000
is very good on receive, and i also would like to use it as a second receiver,
attached to a separate aerial, while transmitting on
my main beam.
|
- [Flexradio] Filter width "problem" Ross
- Re: [Flexradio] Filter width "problem... Eric Wachsmann - FlexRadio