> ----- Original Message ----- > From: Brian Sherrod > To: flexradio > Sent: Wednesday, May 24, 2006 8:18 AM > Subject: [Flexradio] Delta 44 & Audio settings in general > > > I wonder if someone can help me out on some audio issues... > > Reading back over the Delta 44 Quick Start Guide, it states to adjust > the mic gain using the ALC meter during transmit and adjust until the > peaks just reach 0db. It further says to make certain the compressor > is NOT turned on (and I assume the compander too). Problem is, I can > not get it to reach 0db no matter how much I turn up the mic pre-amp > on the console. If I turn on the compressor and compander, I can > reach 0db. > > I don't think it has anything to do with a weak input, as I am using > an outboard mic pre-amp (Behringer Tube Ultragain), and even if I try > to increase the output on the audio chain it will not reach 0db. I > noticed that the document was published when version 1.3.x was > released. Has something changed since then? BTW, I do have In3 set > to -10db as it shows in the document. >
This turned out to be an outdated document (Delta 44 Quick Start Guide), and was updated yesterday to indicate using the MIC level meter and NOT the ALC meter as did the old document. Thanks for all the replies and tips however! I have no problem getting 0db with the MIC level meter, but my audio is still too hot, so I am backing down to about half of that. Thanks, Brian / w5ami _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://mail.flex-radio.biz/pipermail/flexradio_flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com
