Is there a schematic of the SDR-1000 to aid in troubleshooting? TNX Kevin Original Message: ----------------- From: Ignacio [EMAIL PROTECTED] Date: Thu, 14 Sep 2006 16:16:28 +0200 To: [email protected] Subject: Re: [Flexradio] Help - Suggestions
Kevin Hobbs wrote: > > > > > > I just did some additional tests. I ran the scanner until I found something > good .. ie: WWV at 2.8MHz . I disconnected the antenna and connected my sig > gen at 2.5MHz and it was there. So, at the bottom end I seem to be 300KHz or > os. I tried a 5MHz signal and it showed up at about 5.6MHz on the SDR. > Unfortunately, I couldn't find a 10MHz signal (I expected it to be around > 11.2MHz). So, something goofy is going on. Using the scanner I found that I > am receiving lots of signals, but I don't think they are as strong as they > should be and they sure aren't in the right place. > > > > More suggestions to try tomorrow? Bedtime now . thanks for help & > suggestions!!! > > > > TNX Kevin > Kevin, this suggest your LO is not in the right frequency. Can you check the ref oscillator and see if it generating 200 MHz? I had a bad oscillator that drove my crazy. I suggest also resetting the parallel cable and even check the continuity of all wires. -- 73 de Ignacio, EB4APL _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com -------------------------------------------------------------------- mail2web - Check your email from the web at http://mail2web.com/ . _______________________________________________ FlexRadio mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Homepage: http://www.flex-radio.com
