All relevant documents that contain the mic connector drawing have been updated. Once the pin outs for the FlexWire connecter have been published, those documents will be amended as well.
-Tim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jim Lux Sent: Wednesday, July 18, 2007 8:31 PM To: Gerald Youngblood; 'FireBrick'; 'FlexRadio List' Subject: Re: [Flexradio] will the flex5K have At 05:16 PM 7/18/2007, Gerald Youngblood wrote: >There is a switched 13.8V on the FlexWire connector. There is also >switched 5V on the front panel microphone connector. Will the drawing in the knowledge base (article Q10400) be updated to reflect this? James Lux, P.E. Spacecraft Radio Frequency Subsystems Group Flight Communications Systems Section Jet Propulsion Laboratory, Mail Stop 161-213 4800 Oak Grove Drive Pasadena CA 91109 tel: (818)354-2075 fax: (818)393-6875 _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/ _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/
