After trying several things suggested by others, I think my USB
communication PC to/from Janozy is working now.
I can run initozy.bat without errors.
After I run initozy.bat, the correct group of LEDs
light/alternate on the board.
PowerSDR 1.9.1 Beta (from flex-radio site) seems to inter-act
with the SDR1000 (i.e., turning SDR1000 power on/off makes PowerSDR
panadaptor background level bounce up/down and audio output changes a
little. Also, there is a panadaptor hump about 30 dB above background
about 9 kHz below the "tuned" freq.
HOWEVER, PowerSDR finds NO signals - Zilch. Not even my Elecraft xg2.
The SDR1000 is still working OK, because I restored it to the Delta44
card and signals were there again (phew!).
I then reconnected the SDR1000 to the Janozy boards and wiped out the
PowerSDR MDB file and re-built it properly, BUT STILL NO SIGNALS -
same old hump down 9 kHz, etc.
Anyone have ideas to share? I would appreciate hearing them. Since I
have USB communications and I can initialize Janozy, I assume my
initozy.bat and libusb stuff are AOK.
Jerry W4UK
_______________________________________________
FlexRadio mailing list
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/
FlexRadio Knowledge Base: http://kb.flex-radio.com/
FlexRadio Homepage: http://www.flex-radio.com/
