Right. So all of the antenna inputs (including the XVTR ones) would fit into the rightmost block labeled "Radio Frequency Input & Output Switching Matrix".
Eric > -----Original Message----- > From: Jim Lux [mailto:[EMAIL PROTECTED] > Sent: Tuesday, October 16, 2007 10:44 PM > To: Eric Wachsmann; 'ROger Rehr'; 'Dale Boresz' > Cc: flexradio@flex-radio.biz > Subject: Re: [Flexradio] XVRX Input Port on Flex-5000 > > At 02:01 PM 10/16/2007, Eric Wachsmann wrote: > >Note that the XVTR inputs go through the same RX filters as the other > >antenna inputs on the FLEX-5000. > > > Ah.. it wasn't clear from the block diagram. > http://kb.flex-radio.com/article.aspx?id=10380&cNode=4A1H8A > > It shows the Tx coming right out of the QSE, so I assumed the QSD > input was similar. > > _______________________________________________ FlexRadio mailing list FlexRadio@flex-radio.biz http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archive Link: http://www.mail-archive.com/flexradio%40flex-radio.biz/ FlexRadio Knowledge Base: http://kb.flex-radio.com/ FlexRadio Homepage: http://www.flex-radio.com/