Double check that if the two signals are about the same amplitude. If one is much lower than the other, this is normal. Otherwise, as at least one other mentioned, it sounds like the stereo cable connecting the SDR-1000 To Line In to the soundcard may not be making contact on both channels.
Eric Wachsmann FlexRadio Systems > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > radio.biz] On Behalf Of kerry brown > Sent: Sunday, January 20, 2008 7:36 AM > To: Tim Ellison; NU8Z; [email protected] > Subject: [Flexradio] XG1 > > Hi Folks > is there anybody that has used the XG1 for calibration. Should > there be > two signals, I am getting one on 7.040 and another on 7.062, is this > normal. > As there is two signals what one is right? Should I set the calibration > from the 7.040 or the 7.02. When on 14mhz the radio seems to be 22kh out. > Alas I cannot hear > any wwv or any am stations are to wide. Hope anyone can help? or is it > better to delete srd 1.10.3 and start again. It receives well but I do not > think it is in frequency. > > Any Help G7EXO Thanks > > > --------------------------------- > Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it > now. > _______________________________________________ > FlexRadio Systems Mailing List > [email protected] > http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz > Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ > Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex- > radio.com/ _______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kb.flex-radio.com/ Homepage: http://www.flex-radio.com/
