Folks,
If you use the current release of PowerSDR 1.18.2, and any of the
latest versions of the SVN Test branches (alpha code) you will see this
pop up. To remove this screen while running either version, you will
need to run the Production Test => RX Image Test only. But there is a
difference between 18.2 and the Test branches so to get the very best
results, the RX Image will need to be run, more complete instructions
in the link below, usually only the Image Test needs to be run. If you
have the second receiver in the 5K, just do the ctrl - shift - R to
access the RX2 Production test.
http://kc.flex-radio.com/KnowledgebaseArticle50140.aspx
If you only run the current versions, and this screen pops up about the
Image Calibration Required, just run the test, let it run on all bands
and it will write this to the EEPROM, you should not see the pop up
again with PSDR 1.18.2.
This will not keep either the current version or the Test version from
running, just that the image rejection will not be optimized..
Hope this helps,
--
73,
Dudley
WA5QPZ
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
Message delivered to [email protected]
