I am having no success with DigiPan on my new Flex-3000. FF details:
using vCOM, COM16/COM6, and VAC on Dell XPS/VISTA. -3000 & DigiPan
receives and acts normally in RX mode, but will not go into TX mode;
DigiPan acts normally in TX (e.g. waterfall scroll stops, etc.) but no
signal returns to -3000 via PTT. [DigiPan 2.0 will not accept COM > 9,
therefore reversal of vCOM virtual COM lines.] Clearly at least 1 of the
VAC lines is working, since PowerSDR talks to DigiPan as far as
receiving signals goes...
I have tried various combinations of CAT/PTT and PTT alone with no
success. I would appreciate details of setup from anyone using DigiPan
with PowerSDR/Flex-3000.
Flex-3000 operates normally in CW mode.
Thanks, John Ragle -- W1ZI
[email protected]
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flex-radio.com/ Homepage: http://www.flex-radio.com/
Message delivered to [email protected]
