I need help getting v2.0.16 installed and running with the Flex-1500. I previously had v2.0.5 running fine on CW (never could get v2.0.8 to run CW without gliches). Recently decided to try to get PSK/RTTY modes setup with the VAC and thought it was a good time to upgrade to v2.0.16. Mistake. I get the no receive signal, divided Panadapter display or 'flat-line audio' I think it is called, and no audio out. PowerSDR updated the 1500 firmware and I have the two drivers in the Windows device step. Computer is a dual core Windows 7 32bit system. I would like to either get v2.0.16 installed and running or go back to v2.0.5 but I lost 2.0.5 and can't find it on the Flex web site. I tried the driver troubleshooting steps and am now hopelessly lost. Help appreciated. Bob, k9foh. [email protected]
_______________________________________________ FlexRadio Systems Mailing List [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/ Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
