If this is correct, I'd like to know more about using the Flexradio Audio
lines...
I was under the impression that selecting the flexradio audio was to be
avoided for some reason...
Any info forthcoming...?
73...Jordan VE6ZT
----- Original Message -----
From: "Marshall" <[email protected]>
To: <[email protected]>
Sent: Monday, July 02, 2012 1:04 PM
Subject: Re: [Flexradio] CW Skimmer not decoding I/Q
Thanks for all the replies. I followed a suggestion by Bill, W9OL, and set
the CWS Signal I/O device to "Flexradio Audio", which I understand to be
the direct I/Q data from the Firewire driver. This is working perfectly,
and I like that I do not have to change PowerSDR settings to use VAC for a
digimode program like DM780. If there are drawbacks to this approach, I
would appreciate feedback.
Tim, at your suggestion, I tried setting the Win7 Audio device to
2-channel, which I did before starting the radio or any programs, but it
does not work. I must be missing some other setting on VAC, but I think I
will give up for now.
Thanks again to all who replied, both on and off list.
73,
Marshall N5JPJ
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage:
http://www.flexradio.com/
_______________________________________________
FlexRadio Systems Mailing List
[email protected]
http://mail.flex-radio.biz/mailman/listinfo/flexradio_flex-radio.biz
Archives: http://www.mail-archive.com/flexradio%40flex-radio.biz/
Knowledge Base: http://kc.flexradio.com/ Homepage: http://www.flexradio.com/
